Errata for Tubular Heat Exchanger Inspection, Maintenance and Repair as of August 28, 2001

• Page No. iv, Line No. 3, Change "head" to read "heat", and "repaire" to read "repair".
• Page No. 44, Table 2.1 3, Under the TEMA column in English, change the third 0.225 to 0.225 (bolded).
• Page No. 60, Line No. 5, Change "ubble" to read "bubble".
• Page No. 60, Line No. 18, Change "Inspector" to lower case "inspector".
• Page No. 92, Line No. 21, Change the first "HydroPull to read "HydroPro".
• Page No. 156, Line No. 6, Change 0.127 mm (~0.005 in) to read 0.050 mm (~0.002 in).
• Page No. 169, Change equation 5.1 to read . Pressures are absolute values.
• Page No. 170, Line No. 24, Change "reiterate" to "iterate".
• Page No. 192, Line No. 24, Change "feedwater heaters" to read "manway opening".
• Page No. 195, Line No. 14, Change "and" to read "an".
• Page No. 263, Line No. 6 from bottom, Change "breech- lock" to read "breech-block".
• Page No. 264, Line No. 9, Change "breech-lock" to read "breech-block".
• Page No. 276, Fig. 9.7, Bolting Sequence line, change 5, 10, 20 to read 5, 15, 10, 20.
• Page No. 280, Line No. 9, Change "replacing" to read "refacing".
• Page No. 290, Line No. 10, Delete "at" between "SCC" and "below".
• Page No. 297, Line No. 13 from bottom, Change "In feedwater desuperheaters" to read "In desuperheaters".
• Page No. 320, Line No. 22, Change 14,000 psi (about 96,500 kPa) to 20,000 psi (about 137,900 kPa)
• Page No. 333, Line No. 10, Insert R_tplugged between "film resistance" and (=1/_htplugged).
• Page No. 339, Eq. (10.14), Insert W in front of the expression on the right side. Relocate the exponent 0.556 inside the parenthesis to raise the bracketed expression to the power.
• Page No. 350 Lines Nos. 8 and 11, Change 25 mm to read 0.025 mm in both places.
• Page No. 381, 2nd reference 3, Change "Tarreytown" to read "Tarrytown".
• Page No. 427, 4th line from bottom, Change ~54 ° C to read ~16.7° C.
• Page No. 475, Line No. 14, Change "Riles" to read "Rules".